10-16-2010, 08:13 PM
Dear students,
Please follow the screenshots/steps for intallation of DevC++ on WindowsXP.
1. Download DevCpp from vulms.vu.edu.pk. Click on the link VU Content Library (/Library/library.aspx) on the bottom right side as shown in figure below.
[ATTACH=CONFIG]1617[/ATTACH]
2. Click on CS201-Introduction to Programming link and then click on DevC++ setup as shown in the figure below. Save the setup on your local drive.
[ATTACH=CONFIG]1618[/ATTACH]
3. Unzip the downloaded setup and then run setup file. The following window will be displayed. Select English and click OK button.
[ATTACH=CONFIG]1619[/ATTACH]
Now window shown in the figure below will be displayed. Select Typical from menu and click on Next button.
[ATTACH=CONFIG]1620[/ATTACH]
5. Now window in the figure below will be displayed. Select the location where you want to install DevCpp and then click on Install button.
[ATTACH=CONFIG]1621[/ATTACH]
6. After completion of intallation, following window will be displayed. Click on Finish button.
[ATTACH=CONFIG]1622[/ATTACH]
7. Now you will get "First time configuration" wizard. Click on Next button as shown in figure below.
[ATTACH=CONFIG]1623[/ATTACH]
8. After completion of configuration, you will get the following window. Click on OK button.
[ATTACH=CONFIG]1624[/ATTACH]
9. Now you will get the main interface of DevCpp. As shown in the window below.
[ATTACH=CONFIG]1625[/ATTACH]
10. Now click on the File menu and Click on New and then select Source File.
[ATTACH=CONFIG]1626[/ATTACH]
11. Write the program in the new file. Then save the file on the local disk.
Note: A sample "Hello World" program is given in the screenshot. Please follow the same code template in your programs.
Please follow the screenshots/steps for intallation of DevC++ on WindowsXP.
1. Download DevCpp from vulms.vu.edu.pk. Click on the link VU Content Library (/Library/library.aspx) on the bottom right side as shown in figure below.
[ATTACH=CONFIG]1617[/ATTACH]
2. Click on CS201-Introduction to Programming link and then click on DevC++ setup as shown in the figure below. Save the setup on your local drive.
[ATTACH=CONFIG]1618[/ATTACH]
3. Unzip the downloaded setup and then run setup file. The following window will be displayed. Select English and click OK button.
[ATTACH=CONFIG]1619[/ATTACH]
Now window shown in the figure below will be displayed. Select Typical from menu and click on Next button.
[ATTACH=CONFIG]1620[/ATTACH]
5. Now window in the figure below will be displayed. Select the location where you want to install DevCpp and then click on Install button.
[ATTACH=CONFIG]1621[/ATTACH]
6. After completion of intallation, following window will be displayed. Click on Finish button.
[ATTACH=CONFIG]1622[/ATTACH]
7. Now you will get "First time configuration" wizard. Click on Next button as shown in figure below.
[ATTACH=CONFIG]1623[/ATTACH]
8. After completion of configuration, you will get the following window. Click on OK button.
[ATTACH=CONFIG]1624[/ATTACH]
9. Now you will get the main interface of DevCpp. As shown in the window below.
[ATTACH=CONFIG]1625[/ATTACH]
10. Now click on the File menu and Click on New and then select Source File.
[ATTACH=CONFIG]1626[/ATTACH]
11. Write the program in the new file. Then save the file on the local disk.
Note: A sample "Hello World" program is given in the screenshot. Please follow the same code template in your programs.