06-29-2011, 10:12 PM
10. Enter the values of VPI = 0 & VCI = 103 for copper (Note: For ONU use VPI=8 &
VCI=81) and check “Enable Quality of Service” and click Next as shown under.
[ATTACH=CONFIG]3178[/ATTACH]
13. Uncheck the “Enable Firewall” checkbox and click Next as shown below.
[ATTACH=CONFIG]3179[/ATTACH]
14. “WAN Setup Summary” page is displayed showing the settings/configurations, click Save
button to save the configurations.
[ATTACH=CONFIG]3180[/ATTACH]
15. Click Save/Reboot, a message window is shown, click OK to save the changes.
[ATTACH=CONFIG]3181[/ATTACH][ATTACH=CONFIG]3182[/ATTACH]
16. DSL Router Reboot window is shown. Wait until the next window is shown displaying
the Device Info.
[ATTACH=CONFIG]3183[/ATTACH]
17. Go again to Internet Protocol (TCP/IP) Properties and Select Obtain an IP address
automatically and leave the DNS server addresses unchanged as shown in the picture
below and press Ok.
[ATTACH=CONFIG]3184[/ATTACH]
Open the Internet Explorer and start browsing the sites for successful configuration and DSL
connection establishment.
VCI=81) and check “Enable Quality of Service” and click Next as shown under.
[ATTACH=CONFIG]3178[/ATTACH]
13. Uncheck the “Enable Firewall” checkbox and click Next as shown below.
[ATTACH=CONFIG]3179[/ATTACH]
14. “WAN Setup Summary” page is displayed showing the settings/configurations, click Save
button to save the configurations.
[ATTACH=CONFIG]3180[/ATTACH]
15. Click Save/Reboot, a message window is shown, click OK to save the changes.
[ATTACH=CONFIG]3181[/ATTACH][ATTACH=CONFIG]3182[/ATTACH]
16. DSL Router Reboot window is shown. Wait until the next window is shown displaying
the Device Info.
[ATTACH=CONFIG]3183[/ATTACH]
17. Go again to Internet Protocol (TCP/IP) Properties and Select Obtain an IP address
automatically and leave the DNS server addresses unchanged as shown in the picture
below and press Ok.
[ATTACH=CONFIG]3184[/ATTACH]
Open the Internet Explorer and start browsing the sites for successful configuration and DSL
connection establishment.