06-29-2011, 11:31 PM
7. Configure Internet Connection – WAN IP Settings window is shown. Select “Obtain an
IP address automatically” and check “Enable NAT” and click Next.
[ATTACH=CONFIG]3203[/ATTACH]
8. Configure Internet Connection – PPP User Name and Password window is shown. Enter
the “PPP User Name & PPP Password” as provided by the ISP and click Next
[ATTACH=CONFIG]3204[/ATTACH]
9. Configure LAN side Settings window is shown. Enable the DHCP Server by checking
“Enable DHCP Server on the LAN” and click Next
[ATTACH=CONFIG]3206[/ATTACH]
10. Now, a window with the title Quick Setup – Summary is shown, displaying the Settings /
Configurations of Setup. Click Apply to accept and save the settings.
[ATTACH=CONFIG]3207[/ATTACH]
11. Reboot DSL Router is shown with the message “The DSL Router has been configured and
is rebooting”. Wait till the window with the title “Connect to Internet” is displayed.
[ATTACH=CONFIG]3208[/ATTACH]
12. Finally, the DSL router is connected.
[ATTACH=CONFIG]3209[/ATTACH]
13. Go again to Internet Protocol (TCP/IP) Properties and Select Obtain an IP address
automatically and leave the DNS server addresses unchanged as shown in the picture
below and press Ok.
[ATTACH=CONFIG]3210[/ATTACH]
IP address automatically” and check “Enable NAT” and click Next.
[ATTACH=CONFIG]3203[/ATTACH]
8. Configure Internet Connection – PPP User Name and Password window is shown. Enter
the “PPP User Name & PPP Password” as provided by the ISP and click Next
[ATTACH=CONFIG]3204[/ATTACH]
9. Configure LAN side Settings window is shown. Enable the DHCP Server by checking
“Enable DHCP Server on the LAN” and click Next
[ATTACH=CONFIG]3206[/ATTACH]
10. Now, a window with the title Quick Setup – Summary is shown, displaying the Settings /
Configurations of Setup. Click Apply to accept and save the settings.
[ATTACH=CONFIG]3207[/ATTACH]
11. Reboot DSL Router is shown with the message “The DSL Router has been configured and
is rebooting”. Wait till the window with the title “Connect to Internet” is displayed.
[ATTACH=CONFIG]3208[/ATTACH]
12. Finally, the DSL router is connected.
[ATTACH=CONFIG]3209[/ATTACH]
13. Go again to Internet Protocol (TCP/IP) Properties and Select Obtain an IP address
automatically and leave the DNS server addresses unchanged as shown in the picture
below and press Ok.
[ATTACH=CONFIG]3210[/ATTACH]